Magnetic Tape for AGV Magnetic Guide Sensor
MGT series magnetic guide tape is used for magetic guide sensors.
Features
- Magnet: Anisotropic strontium ferrite (Binder; Chlorinated polyethylene polymer alloy)
- Residual magnetic flux density; Br 220~245mT (2200~2450G)
- Coercivity; bHc 159~183kA/m (2000~2300Oe)
- iHc207~262kA/m (2600~3300Oe)
- Maximum energy product; B·H (max)9.03~10.8kJ/m3 (1.13~1.35MGOe)
- Operation temperature:-20~+60ºC
- Storage temperature:-30~+70ºC
Dimension
MGT-50-25 50mm wide, 2mm thick, 25m long, magnet only or with self-adhesive tape
Installation
- Remove dust, water or oil from floor surface.
- Peel off the release liner and stick it on the floor along AGV route.
Notices
- Magnetic guide tape can be attached on ferrous material floor but should not be embedded in ferrous material floor, since the magnetic flux from the guide tape is greatly reduced.
- Magnets at vicinity of magnetic Guide ape may cause turbulence of magnetic flux distribution . proximity of strong magnet ( approx 1 KGs and more ) to magnetic guide tape may change the magneic flux distribution of guide tape.
- Normal running routes should keep distance more than 500 each other.
- Adhesion of ferrous powder iron etc. on magnetic guide tape may cause reduction of magnetic flux density. Remove the adhesive ferrous powder from guige tape regularly.
- Each end of magnetic guide tape should be connected within 2 mm slit.
- Keep chemicals and solvent (acetone, thinner, etc.) away, since it may change the shape and characteristics of magnetic guide tape.
- Nonferrous material (aluminum, SUS-304, etc.) can cover magnetic guide tape for protection. But ferrous material (iron, SUS-303, etc.) should not cover magnetic guide tape since magnetic flux from magnetic guide tape is shielded at the area where is covered by ferrous material.
* Specifications are subject to change without notice. *
Photos
Audited Supplier 
){kind=link}