Customization: | Available |
---|---|
Type: | Magnetic Displacement Sensor |
Output Signal Type: | Analog Type |
Still deciding? Get samples of $ !
Request Sample
|
Suppliers with verified business licenses
Audited by an independent third-party inspection agency
Commodity Parameter | Electrical data |
Measurement range | 20°-360°,increment is 1° |
Supply Voltage | 9V to 30Vdc unregulated,5Vdc±0.5Vdc regulated. |
Supply current | ≤25mA(Each channel 12.5mA) |
Provides reverse propality protection | Yes |
Ground short circuit protection output | Yes |
Provide short circuit protection output | Only in 5V regulation mode |
Overvoltage protection | up to 40V(-40ºC~60ºC) |
Power-on settlement | <1s |
Resolution 12 bits | 0.025% of measurement range |
Output range | ±1% of range in 5V regulated power mode |
±1% of measurement range ±3% of output in unregulated 9-30V power mode | |
Nonlinear | <±0.4% |
Temperature coefficient | Less than ±30PPM/ºC in 5V regulated power mode |
Less than ±90ppm/ºC in 9-30V power mode | |
Output(see drawing 2) | |
Options | Ratio Analog or Analog |
Direction | Factory programming sets to increase or decrease with CW Axis rotation. |
Analog output options | |
Voltage output range(9-30V power supply) | within the measuring range 0.5V-4.5V's voltage |
Voltage output range(5V power supply) | Ratiometric output voltage from 10%-90% |
The Voltage supply is monotonic within the measurement range between | |
0.25V(5%)to 4.75V(95%) nominal voltage. | |
Load resistance | <10KΩ(Resistance to ground) |
Step response time | Typical 4mS |
Output noise | <1mVrms |
Frequency response | Norminal 40Hz(-3dB) |
PWM output option | |
PWM frequency | 244Hz+/-20% over temperature range |
PMW Level(9-30V power supply) | 0V and 5V Norminal 0V and V power supply |
PWM Level(5V power supply) | Exceeding the measuring range 10%~90% |
Monotonic range | 5%95% Norminal Value |
Mechanical parameters | Mechanical angle torque |
Mechanical angle torque | 360° continuous |
Maximum running speed | 3600 o/s |
Weight | <35g |
Installation | 2*M4 Screws |
Cable outlet | 500mm 4-core cable FDR-25 jacket 55A specification cable(black=ground,red=V+power, yellow=output 1,white=output2) |
When the shaft and cable outlet are aligned,the sensor is in the middle electrical angle. |